Volkswagen Golf Service & Repair Manual: Removing and installing rear senders
– |
Remove rear wheel housing liner
→ General body repairs, exterior; Rep. gr.66. |
|
|
|
– |
Press both locking lugs in direction of arrow
-A- while at the same time pressing
in sender -1- as far as stop. |
– |
Disconnect electrical connector -2-. |
Install in the reverse order of removal, observing the
following: |
Note
When inserting the sender in the sender retainer, make sure
that the isolation ring (black silicone ring) is seated
correctly on the sender head. |
Both locking lugs of sender retainer must audibly engage
when installing the sender. |
|
|
|
Removing
–
Remove wheel housing liner
→ General body repairs, exterior; Rep. gr.66.
...
Other materials:
Contact corrosion
Contact corrosion can occur if unsuitable fasteners (bolts,
nuts, washers, etc.) are used.
Therefore, only fastening elements with a special surface
coating are installed in the vehicle.
In addition, rubber and plastic p ...
Removing and installing mirror cover trim
Note
Removal and installation are described for the mirror
cover trim on driver side. Follow same instructions for the
front passenger side as appropriate.
Removal and ins ...
Trailer socket
The trailer socket must be connected in accordance with the
manufacturer's instructions to the electrical system of the
pulling vehicle.
When installing, observe the relevant current flow diagrams
and the installation instructions from t ...
© 2016-2024 Copyright www.vwgolf.org