Volkswagen Golf Service & Repair Manual: Removing and installing rear seat backrest cover and padding
| Special tools and workshop equipment
required |
|
|
|
| |
|
Removal wedge -3409 |
| – |
Remove rear seat backrest
→ Chapter. |
| – |
Remove rear head restraint
→ Chapter. |
| – |
Remove trim for locking mechanism
→ Chapter. |
| – |
Remove net partition mounting on right rear seat backrest
(2/3)
→ Chapter. |
| Continued for all vehicles |
|
|
|
| – |
Release clips -2- in area of
inner support pin from backrest cover -1-. |
|
|
|
| Left rear seat backrest (1/3) |
| – |
Starting at locking mechanism, lever beading strip
-2- for backrest cover all round
off backrest frame -3--arrow- using
a screwdriver. |
| – |
Remove rear head restraint guides
→ Chapter. |
| – |
Remove backrest cover -1- with
backrest padding from backrest frame. |
|
|
|
| Right rear seat backrest (2/3) without through-loading
aperture |
| – |
Remove rear centre belt guide
→ Chapter. |
| – |
Starting at locking mechanism, lever beading strip
-2- for backrest cover all round
off backrest frame -3--arrow- using
a screwdriver. |
| – |
Remove rear head restraint guides
→ Chapter. |
| – |
Remove backrest cover -1- with
backrest padding from backrest frame. |
|
|
|
| Right rear seat backrest (2/3) with through-loading aperture |
| – |
Remove rear centre belt guide
→ Chapter. |
| – |
Remove lid for through-loading aperture with rear centre
armrest
→ Chapter. |
| – |
Remove cover frame for through-loading aperture
→ Chapter. |
| – |
Starting at locking mechanism, lever beading strip
-2- for backrest cover all round
off backrest frame -3--arrow- using
a screwdriver. |
| – |
Lever beading strip -4- for
backrest cover all round off through-loading aperture using a
screwdriver. |
| – |
Remove rear head restraint guides
→ Chapter. |
| – |
Remove backrest cover -1- with
backrest padding from backrest frame. |
|
|
|
| Install in reverse order, but note the following: |
| – |
Fold beading strip -1- 90°
inwards -arrow A-. |
| – |
Attach side beading strips into grooves in backrest frame
-arrow B-. |
| – |
Attach fastening frame into backrest frame in area of head
restraint. |
|
|
|
Removing
–
Remove rear bench seat
→ Chapter.
–
...
Removing
–
Fold down lid for through-loading aperture.
–
Release locking lugs -1- using
a screwdri ...
Other materials:
Brake fluid
Fig. 144 In the engine compartment: cap
on the brake fluid container
First read and observe the introductory information
and safety warnings Brake fluid will gradually absorb water from the surrounding
air. The brake system will be damaged if there is too much water in the brake fluid.
T ...
Connecting brake pedal to brake servo
Hold ball head of plunger rod in front of mounting and push
brake pedal in direction of brake servo, so that the ball head
clicks into place.
–
Check engagement by pulling briefly on brake pedal.
...
Front camera for driver assist systems
Calibrating front camera for driver assist systems
Note
The following situations can cause the camera function to be
impaired by sustained poor visibility of the lane marker lines:
The field of view of the camera is soiled or i ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing bench seat cover and padding
Removing and installing intermediate padding, backrest with through-loading
aperture