In the factory a sealant is applied to the rear lid seal, the seal is fitted to the body flange and then rolled on.
Note
Removing |
– | Pull seal -1- off body flange -2-. |
Installing |
– | Align seal -1- with vulcanised point for securing the gas strut -arrows-. |
– | Press seal -1- evenly onto body flange by hand. |
Functional description
The auxiliary and supplementary heater can be started by
means of the remote control, the instant heating button or
appropriate programming in the central monitor. The
supplementary heater mode is started automatically by the
vehicle electronics system o ...
Electric windows – functions
First read and observe the introductory information
and safety warnings One-touch opening and closing
One-touch opening and closing makes it possible to fully open and close the windows.
The individual buttons do not have to be held down to do this.
For one-touch closing: pull the button fo ...
Assembly overview - glove compartment
1 -
Glove compartment
Removing and installing
→ Chapter
2 -
Damper element
For glove compartment lid
With glove compartment light switch -E26-
Removing and installing
→ Chapter
3 -&nbs ...