Volkswagen Golf Service & Repair Manual: Removing and installing rear lid

Volkswagen Golf Service & Repair Manual / General body repairs, exterior / Bonnet. flaps.cab. central loking / Rear lid / Removing and installing rear lid

Special tools and workshop equipment required

Removing

Torque wrench -V.A.G 1331-

Removing and installing rear lid

–	Remove upper rear lid trim → General body repairs, interior; Rep. gr.70.

–	Remove lower rear lid trim → General body repairs, interior; Rep. gr.70.

–	Remove high-level brake light → Electrical system; Rep. gr.94

–	Remove connectors of all installed electrical components.

–	Thread electric cables/wire together with rubber grommet -2- out of rear lid.

Note

The connectors -4- for wires -2- are located on left C-pillars.

–	Loosen bolts -5- on left and right hinges (do not unbolt completely).

Further dismantling requires the assistance of a second mechanic.

–	Remove gas struts -3- → Chapter.

–	Now, remove bolts -5- completely and then remove rear lid -1-.

Installing

Removing and installing rear lid

–	Install rear lid -1- with the aid of a 2nd mechanic.

–	Install gas struts -3- → Chapter.

–	Guide wires -2- into rear lid and attach rubber grommet.

–	Connect connectors of all installed electrical components.

Further installation is performed in the reverse order of removal.

–	Before closing rear lid, check function of lid release components.

–	Adjusting rear lid → Chapter.

Assembly overview - rear lid

1 - Rear lid Removing and installing → Chapter Adjusting → Chapter 2 - Bonnet lock Removing and insta ...

Adjusting rear lid

Special tools and workshop equipment required Torque wrench -V.A.G 1331- ...

Other materials:

Introduction
This chapter contains information on the following subjects: → Function When the toll card system is switched on and functioning, tolls will be charged automatically when driving through a toll booth. The charge will be confirmed by an acoustic signal. The charges will be relayed ...

Overview of fitting locations - components inside of front passenger compartment, LHD vehicles
1 - Left vent temperature sender -G150- Only vehicles with Climatronic. Checking: Use vehicle diagnostic tester in “Guided fault finding” mode and → Current flow diagrams, Electrical fault finding and Fitting locatio ...

Connectors
Repairs to wiring harnesses and connectors Note All instructions and notes regarding this chapter are available under → Electrical System, General Information; Rep. gr.97. ...