Volkswagen Golf Service & Repair Manual: Removing and installing rear left vehicle level sender -G76-, multi-link
suspension, front-wheel drive
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1410- |
|
|
|
– |
Disconnect connector -1-. |
– |
Remove bolts -2- and
-3-. |
– |
Take out rear left vehicle level sender -G76--4-. |
Install in reverse order of removal, observing the
following: |
Lever on vehicle level sender must face towards outside of
vehicle. |
Perform basic setting of wheel damper electronics
→ Vehicle
diagnostic tester. |
Carry out basic setting of headlights
→ Electrical system; Rep. gr.94. |
→ Chapter „Assembly overview - rear vehicle level senders,
multi-link suspension, front-wheel drive“ |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removin ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removin ...
Other materials:
Fitting a bicycle carrier on the mechanically positioned ball coupling
First read and observe the introductory information
and safety warnings The maximum permitted load on a bicycle carrier mounted
on the ball coupling is 80 kg at a distance of 300 mm. This distance
refers to the gap between the centre of gravity of the bicycle carrier (complete
with bicycle ...
Assembly overview - A-pillar trim
Note
The illustration shows the A-pillar trims on the left side.
The right-hand side is similar (mirror image of left-hand side).
Upper A-pillar trim and trim for triangular window
1 -& ...
Removing and installing tank flap unit, e-Golf
Removing
–
Remove wheel housing liner
→ Chapter.
–
Disconnect connector -2- for switch
-3-.
–  ...
© 2016-2024 Copyright www.vwgolf.org