Volkswagen Golf Service & Repair Manual: Removing and installing rear door trim

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Trim, noise insulation / Rear door trims / Removing and installing rear door trim

Note

Removal and installation is described for the rear door trim on driver side. Follow same instructions for the front passenger side as appropriate.

Special tools and workshop equipment required

Removal wedge -3409-

Wedges -T10383-

Removing

Vehicles without electric window regulator

–	Remove window winder → General body repairs, exterior; Rep. gr.58.

Continued for all vehicles

–	Switch off ignition and all electric loads and then remove ignition key.

Torque wrench -V.A.G 1783-

–	Lever upper part of handle recess -1- out of mountings in door trim, using removal wedge -3409-.

Removing and installing rear door trim

–	Remove bolts -1-.

–	Remove reflector → Electrical system; Rep. gr.96.

Removing and installing rear door trim

–	Release retaining clip -1- with Torx T30 by turning it 90° (¹/₄ turn) in -direction of arrow-.

Removing and installing rear door trim

–	Force retaining clips -2- of door trim -1- out of mountings with wedges -T10383-. Clip -3- has already been released.

–	Pull door trim -1- upwards vertically out of window slot seal.

–	Disconnect the electrical plug-in connections from the door trim -1- in accordance with the vehicle's equipment.

–	Unhook Bowden cable -1- from inner door handle.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.
Install in reverse order, but note the following:

–	Insert retaining clips into rear door trim.

Removing and installing rear door trim

Caution

Before installing door trim, ensure that the locking mechanisms of all clips are in -position 1-.

It is not possible to install the door trim without problem if clips are in -position 2-!

Removing and installing rear door trim

Specified torques

→ Chapter „Assembly overview - rear door trim“

Assembly overview - rear door trim

Note The assembly overview is shown for the rear door trim on driver side. The assembly overview for the front passenger side is analogous. 1 - D ...

Removing and installing trim panel

Note Removal and installation are described for the trim panel on driver side. Follow same instructions for the front passenger side as appropriate. ...

Other materials:

Dismantling and assembling heater unit
It is not necessary to extract the refrigerant and to remove or disassemble the expansion valve and the evaporator. Further procedure is identical with procedure for vehicles with air conditioning system → Chapter. ...

Loosening and tightening threaded connections of drive shaft
Special tools and workshop equipment required Socket, 24 mm -T10361A- Angle wrench -V.A.G 1756 A- ...

Removing and installing refrigerant shut-off valve for high-voltage battery heat exchanger -N542
Removing – Observe safety precautions → Chapter „Safety precautions when handling refrigerants“. – Comply with notes → Chapter „Working on refrigerant circuit“. ...