Volkswagen Golf Service & Repair Manual: Removing and installing rear body acceleration sender -G343-
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1410- |
– |
Remove left luggage compartment side trim
→ General body repairs, interior; Rep. gr.70. |
|
|
|
– |
Release electrical connector -1-
and pull off. |
– |
Unscrew bolt -2-, and remove
rear body acceleration sender -G343--3-. |
Install in reverse order of removal, observing the
following: |
|
|
|
– |
Insert rear body acceleration sender -G343--1-
so that lug -arrow A- engages into
hole -arrow B-. |
– |
Perform basic setting of wheel damper electronics
→ Vehicle
diagnostic tester. |
|
|
|
Component |
Specified torque |
Rear body acceleration sender
-G343- to body |
8 Nm |
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Re ...
Other materials:
Changing a blown fuse
Fig. 232 Blown fuse: A: flat blade fuse,
B: JCASE® fuse
Fig. 233 Remove or insert fuse with plastic
pliers: A. flat blade fuse, B. JCASE® fuse
First read and observe the introductory information
and safety warningsPreparation
Switch off the ignition, the lights and all electrical co ...
Removing and installing roof spoiler
Removing
Note
The side spoiler remains installed.
–
Remove rear lid trim
→ General body repairs, interior; Rep. gr.70.
–&nb ...
Removing and installing support for luggage compartment floor, saloon
Note
Removal and installation are described for the left vehicle
side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...
© 2016-2024 Copyright www.vwgolf.org