VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing rear belt guide

Removing
–  Remove luggage compartment side trim, estate → Chapter.
   
–  Unscrew the 2 bolts -1-, and remove belt guide -2-.
Installing
Installation is carried out in reverse order.
  Note
Observe correct installation position of the belt guide when installing.
Specified torques
  → Chapter „Assembly overview - three-point seat belt, estate, without belt tensioner“
  → Chapter „Assembly overview - three-point seat belt, estate, with belt tensioner“
 

Removing and installing rear belt guide

Removing and installing rear centre three-point seat belt
Removing –  Remove backrest cover with backrest padding from rear seat backrest → Chapter.   & ...

Removing and installing rear outer belt end fitting
Removing     –  Unscrew bolt -1- on belt end fitting -2-. Installing ...

Other materials:

Assembly overview - data bus diagnostic interface
1 -  Electrical connector For data bus diagnostic interface -J533- 2 -  Data bus diagnostic interface -J533- Removing and installing → Chapter 3 -  Bolt Spe ...

Removing and installing rain and light sensor, vehicles with front camera for driver assist systems
  Note The rain and light sensor has a silicon layer (coupling pad) which forms the contact surface to the windscreen. The rain and light sensor has been designed so that it can be used again. A prerequisite for re-use ...

12 V socket
Removing and installing 12 V socket   Caution If excessive force is exerted on sockets without illumination, the retaining sleeve may be damaged. Only illuminated sockets (cigarette lighter) ...

© 2016-2026 Copyright www.vwgolf.org