Volkswagen Golf Service & Repair Manual: Removing and installing rear axle, torsion beam axle

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Rear suspension, drive shaft / Rear axle / Removing and installing rear axle, torsion beam axle

Special tools and workshop equipment required

Torque wrench -V.A.G 1332-

Removing and installing rear axle, torsion beam axle

Engine and gearbox jack -V.A.G 1383 A-

Removing

–	Loosen wheel bolts.

–	Raise vehicle.

–	Remove rear wheels.

–	Release and pull off connector on rear left and right speed sensors.

–	Remove left and right brake calipers and tie to body with wire → Brake system; Rep. gr.46.

Removing and installing rear axle, torsion beam axle

–	Unclip electric cable -1- from both sides -arrows- of retainer -2- on axle beam.

Vehicles with vehicle level sender

Removing and installing rear axle, torsion beam axle

–	Release and pull off connector -1- on rear left vehicle level sender -G76-.

–	Unclip line -2- from clip -arrow-.

Continuation for all vehicles

Removing and installing rear axle, torsion beam axle

–	Unclip brake line -1- from clip -arrow- on right mounting bracket.

Note

The clip will be destroyed and must be renewed.

–	Remove springs → Chapter.

–	Use tensioning straps -T10038--1- to strap vehicle to support beams of lifting platform on both sides.

WARNING

If the vehicle is not strapped down, there is a great danger that the vehicle will slip off the lifting platform!

–	Position engine and gearbox jack -V.A.G 1383 A-.

Removing and installing rear axle, torsion beam axle

–	Unclip electrical wiring -2- at mounting bracket -1- and axle beam and move clear.

–	Mark positions of bolts -arrows- on mounting bracket -1- on left and right sides of vehicle and remove them.

–	Slightly take up weight of rear axle using engine and gearbox jack -V.A.G 1383 A--1-.

Removing and installing rear axle, torsion beam axle

–	Unbolt rear axle from shock absorbers -arrows-.

–	Lower rear axle with engine and gearbox jack -V.A.G 1383 A--1-.

1 -	Engine and gearbox jack -V.A.G 1383 A-

2 -	Universal gearbox support -V.A.G 1359/2-

Installing

Install in reverse order of removal, observing the following:

Tighten bolted connection securing shock absorber to axle beam with suspension in unladen position → Chapter.

Specified torques

→ Chapter „Assembly overview - axle beam“

→ Chapter „Assembly overview - suspension strut, shock absorber, spring, torsion beam axle“

→ Chapter „Torque settings for wheel bolts“

Bolts for brake caliper and brake disc → Brake system; Rep. gr.46

On vehicles with vehicle level sender, carry out basic settings for wheel damper electronics → Vehicle diagnostic tester

On vehicles with vehicle level sender, carry out basic adjustment of headlights → Electrical system; Rep. gr.94.

Removing and installing rear axle, torsion beam axle

Lowering rear axle, multi-link suspension, four-wheel drive

Special tools and workshop equipment required Torque wrench -V.A.G 1332- ...

Removing and installing rear axle, multi-link suspension, front-wheel drive, except for e-Golf and Golf GTE

Special tools and workshop equipment required Torque wrench -V.A.G 1332- Engine and gearbox jack -V.A.G 1383 A- Tensioning strap -T10038 ...

Other materials:

Paintwork in Aftersales
Panels galvanised on both sides Earlier attempts at flanged pairings have resulted in the fact that only panels that are galvanised on both sides are used now. Only in this way can the cathodic protection and the barrier effect of the zi ...

Overview of fitting locations - operating and display unit, air conditioning system with electric/manual controls
Note A warning lamp in the instrument panel controls will indicate that the selected function is active. If the warning lamp does not light up after the AC button is pressed, a fault may be stored in the control ...

Connecting brake lines to hydraulic unit, RHD vehicles
On hydraulic unit: 1 - From hydraulic unit to rear left brake caliper. - Identification: Ш 5.25 mm and flare nut with thread M 10 x 1 2 - From hydraulic u ...