Volkswagen Golf Service & Repair Manual: Removing and installing rear 3-point seat belt, estate, with belt tensioner
WARNING
|
Observe safety instructions for pyrotechnic
components
→ Chapter. |
|
Observe disposal regulations for pyrotechnic
components
→ Chapter. |
|
|
|
|
– |
For “e-Golfs” or “Golf GTEs”, disconnect the maintenance
connector for high-voltage system -TW-. |
– |
Disconnect battery earth cable with ignition switched on
→ Electrical system; Rep. gr.27. |
– |
Remove bench seat
→ Chapter. |
– |
Remove rear seat backrest
→ Chapter. |
– |
Remove D-pillar trim
→ Chapter. |
– |
Remove luggage compartment side trim, estate
→ Chapter. |
– |
Remove outer rear seat belt guide anchor
→ Chapter. |
WARNING
Electrostatic discharges may result in
unintentional triggering of airbag. Therefore, the
mechanic must electrostatically discharge him/herself
before disconnecting the igniter and earth wires. This
can be done by briefly touching the body or striker
plate of the door. |
|
|
|
|
– |
For “e-Golfs” or “Golf GTEs”, connect the maintenance
connector for high-voltage system -TW-. |
– |
Connect battery earth cable with ignition switched on
→ Electrical system; Rep. gr.27. |
WARNING
If the ignition has not yet been switched
on after the battery has been reconnected “warning lamps
in dash panel insert are off”, the ignition (key or
button) must only be switched on while sitting on the
driver seat and with the seat set to rearmost position. |
|
|
→ Chapter „Assembly overview - three-point seat belt, estate,
with belt tensioner“ |
|
|
|
Removing
–
Remove bench seat
→ Chapter.
–
Remove rear seat backrest
→ ...
Removing
–
Remove backrest cover with backrest padding from rear seat
backrest
→ Chapter.
& ...
Other materials:
Control and regulating unit for air conditioning system -J127
This control and regulating unit switches off the
refrigerant flow through the second evaporator if the
temperature at the cooling fins of the second evaporator falls
to the freezing point of water (icing protection).
...
Removing and installing valve, metal valve
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Carry out the following work:
Removing
–
R ...
Removing and installing rear window
Note
The removal of a bonded window is described using the
Removal kit for flush bonded windows -V.A.G 1474 A-.
Alternatively, you can also use the cutting tool for bonded
windows -VAS 6452-.
...
© 2016-2024 Copyright www.vwgolf.org