VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing output module for headlight -J667-/-J668-

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Removing and installing output module for headlight -J667-/-J668-

  WARNING
Risk of death due to high voltage! Risk of injury and environmental pollution!
Observe operation and safety notes for gas discharge bulbs → Chapter.
It is essential that the battery earth cable is disconnected before any work on parts of the gas discharge headlight is performed. The parts are marked with a yellow high voltage symbol.
  Note
Output module for left headlight -J667- and output module for right headlight -J668- are only fitted on gas discharge headlights with cornering light.
Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.
Removing
–  Remove headlight → Chapter.
   
–  Remove bolts -2-.
–  Pull output module for left headlight -J667--1- off headlight.
–  Press release button -4-.
–  Disconnect electrical connector -3-.
Installing
Install in the reverse order of removal, observing the following:
  Caution
Make sure seal is correctly seated when installing the gas discharge bulb control unit. The ingress of water will lead to permanent damage to the headlight.
–  Check seal between control unit and headlight for damage.
Specified torques
→ Chapter „Assembly overview - headlight“
 

Removing and installing output module for headlight -J667-/-J668-

Removing and installing gas discharge bulb control unit -J343-/-J344-
  WARNING Risk of death due to high voltage! Risk of injury and environmental pollution! ...

Removing and installing control unit for daytime running light and side light -J860-/-J861-
  WARNING Risk of death due to high voltage! Risk of injury and environmental pollution! ...

Other materials:

Removing and installing glove compartment light -W6-
Removing –  Turn light switch to “0” position.     –  Press in locking lug -1- using a flat screwdriver, and lever out glove compartment light -2-. ...

Warning and indicator lamps
The warning and indicator lamps indicate various warnings  , faults   or certain functions. Some warning and indicator lamps light up when the ignition is switched on and should go out once the engine is running or the vehicle is in motion. Depending on the vehicle equipment level, additio ...

Safety precautions when working on the cooling system
Risk of scalding by hot coolant When the engine is warm, the cooling system is under pressure. Danger of scalding due to steam and hot coolant. –  Always wear safety gloves. –  Always wear safety goggles. –  ...

© 2016-2024 Copyright www.vwgolf.org