Volkswagen Golf Service & Repair Manual: Removing and installing output module 1 for left LED headlight -A31-/-A27-

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Removing and installing output module 1 for left LED headlight -A31-/-A27-

Special tools and workshop equipment required

Torque wrench -V.A.G 1783-

Removing and installing output module 1 for left LED headlight -A31-/-A27-

Torque screwdriver -VAS 6494-

Note

Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.

Removing

–	Remove headlight → Chapter.

Removing and installing output module 1 for left LED headlight -A31-/-A27-

–	Remove bolts -2-.

–	Pull output module 1 for left LED headlight -A31--1- off headlight.

–	Press release button -4- in direction of arrow -A-.

–	Disconnect electrical connector -3-.

Installing

Install in the reverse order of removal, observing the following:

Caution

Make sure the seal is correctly seated when installing the output module 1 for left LED headlight -A31-. The ingress of water will lead to permanent damage to the headlight.

–	Check seal between output module 1 for left LED headlight -A31- and headlight for damage.

Specified torques

→ Chapter „Assembly overview - LED headlights“

Removing and installing output module 1 for left LED headlight -A31-/-A27-

Removing and installing output module 2 for headlights, »R«

WARNING Risk of death due to high voltage! Risk of injury and environmental pollution! ...

Removing and installing control motor sender for VARILIS headlight -G695-/-G696-

Note Control motor sender for left VARILIS headlight -G695- and control motor sender for right VARILIS headlight -G696- are only fitted on gas di ...

Other materials:

Removing and installing rear 3-point seat belt, estate, without belt tensioner
Removing – Remove bench seat → Chapter. – Remove rear seat backrest → Chapter. – Remove D-pillar trim → Chapter. ...

Removing and installing engine control unit -J623- (with protective housing)
Special tools and workshop equipment required Hot air blower -VAS 1978/14A--item 1- with nozzle -2- from wiring harness repair set -VAS 1978 B- Small grinder (com ...

Information stickers and plates
First read and observe the introductory information and safety warnings Safety certificates, stickers and plates showing important vehicle operation information are factory-fitted in the engine compartment and on certain parts such as the tank flap, front passenger sun visor, the driver door ...