Volkswagen Golf Service & Repair Manual: Removing and installing operating and display unit, air conditioning system with electric/manual controls and Climatronic

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Operating and display unit / Removing and installing operating and display unit, air conditioning system with electric/manual controls and Climatronic

Special tools and workshop equipment required

Removal wedge -3409-

Note

If a new Climatronic control unit -J255- or air conditioning system control unit -J301- is installed, the function "Renew control unit", the basic setting and an adaptation (“Compressor first run”) must be carried out in the "Guided fault finding" or in the "Guided functions".

In vehicles with start-stop system, note abort conditions: → Chapter

Removing

Note

The picure shows a vehicle with Climatronic. The removal and installation for vehicles with manual electronic air conditioning is identical.

Removing and installing operating and display unit, air conditioning system with electric/manual controls and Climatronic

–	Unclip trim -1- at marked points -arrows- in -direction of arrow- from operating and display unit using removal wedge -3409-.

Removing and installing operating and display unit, air conditioning system with electric/manual controls and Climatronic

–	Press operating and display unit in direction of the dash panel to release the expansion rivets.

–	Pull out spreader rivets -2- in -direction of arrow A-.

–	Remove operating and display unit -1- in -direction of arrow B-.

Installing

Note

Removing and installing operating and display unit, air conditioning system with electric/manual controls and Climatronic

Overview of fitting locations - operating and display unit, Climatronic

Note A warning lamp in the instrument panel controls will indicate that the selected function is active. In addition, the display of the radio or ...

Other controlling and regulating components

...

Other materials:

Bleeding hydraulic system following standard procedure
Note Bleeding the hydraulic system using brake filling and bleeding equipment -VAS 5234- is described. A pre-pressure of 2 bar is required for bleeding the ABS hydraulic unit -N55-. Specia ...

Permanent underbody protection -D 314 D36 M2-, grey
Designation: Permanent underbody protection -D 314 D36 M2-, grey Issued 02.2010 Product description, permanent underbody protection -D 314 D36 M2-, grey Permanent underbody p ...

Vibration, conducting a road test before balancing wheels
If a customer brings a vehicle to the workshop complaining about “vibration”, a road test is essential prior to balancing the wheels. This will give you information about the nature of the vibration. ...