Volkswagen Golf Service & Repair Manual: Removing and installing onboard supply control unit -J519-, RHD vehicles
 Note
| When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester. |
| – |
Remove ignition key, if inserted. |
| – |
Remove glove compartment
→ General body repairs, Interior; Rep. gr.68. |
|
|
|
| – |
Disconnect connectors -1, 2 and 3-. |
|
|
|
| – |
Press locking detent -1- to
disconnect connectors. |
| – |
Swing retainer in -direction of arrow-
and pull off connector. |
|
|
|
| – |
If present, remove guide -2-.
To do so, release fasteners on guide in direction of arrow
-A-. |
| – |
Remove guide -2- from onboard
supply control unit -J519--1- in
direction of arrow -B-. |
|
|
|
| – |
Release retaining spring at top -2-
in direction of arrow -A-. |
| – |
Pull onboard supply control unit -J519--1-
towards rear -arrow B- out of
bracket. |
| Installation is carried out in the reverse sequence. |
|
|
|
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
&# ...
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
&# ...
Other materials:
Operating the speed limiter
Fig. 164 Left-hand side of the steering
column: switch and buttons for operating the speed limiter
Fig. 165 Left-hand side of the multifunction
steering wheel: buttons for operating the speed limiter
First read and observe the introductory information
and safety warnings
...
Charging totally discharged battery with battery charger -VAS 5095 A-
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
The charger unit automatically recognises totally discharged
batteries ...
Assembly overview - skid plate
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
1 -
Underride guard
Removing
–
Remove bolts -2-,
-3- and -4-.
–
Pull out noise ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing onboard supply control unit -J519-, LHD vehicles
Removing and installing data bus diagnostic interface -J533-