Volkswagen Golf Service & Repair Manual: Removing and installing onboard supply control unit -J519-, LHD vehicles
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester. |
– |
Remove ignition key, if inserted. |
– |
Remove footwell cover on driver side
→ General body repairs, interior; Rep. gr.68. |
– |
Remove lower A-pillar trim
→ General body repairs, interior; Rep. gr.70. |
– |
Remove foot rest
→ General body repairs, interior; Rep. gr.70. |
|
|
|
– |
Unplug electrical connectors -1, 2, 3-. |
|
|
|
– |
Press locking detent -1- to
disconnect connectors. |
– |
Swing retainer in -direction of arrow-
and pull off connector. |
|
|
|
– |
Release retaining springs -arrow-,
swivel onboard supply control unit -4-
out of bracket -5- and remove
downwards. |
Installation is carried out in the reverse sequence. |
|
|
|
1 -
Electrical connector
For data bus diagnostic interface -J533-
2 -
Data bus diagnostic interface -J533-
Remov ...
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
...
Other materials:
Overview of fitting locations – lights in rear doors
1 -
Door warning lamp and entry light
Driver side door warning lamp -W30- and front passenger entry light
-W93-
Front passenger side door warning lamp -W36- and driver side entry
light -W92-
Removing and installing ...
Assembly overview - drive shaft, constant velocity joint VL100
1 -
Outer constant velocity joint
Renew only as complete unit
Removing
→ Anchor.
Installing: drive onto shaft to stop using plastic hammer
Checking
→ Chapter
2&nb ...
Removing and installing coolant pump
Special tools and workshop equipment required
Refractometer -T10007 A-
Drip tray for workshop hoist -VAS 6208-
Hose clip pliers -VAS 6340-
Cooling system charge unit -VAS 6096-
Adapter for cooling ...
© 2016-2024 Copyright www.vwgolf.org