Volkswagen Golf Service & Repair Manual: Removing and installing oil spray jets

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Enginecrankshaft group, pistons / Pistons and conrods / Removing and installing oil spray jets

Special tools and workshop equipment required

Socket -T10545-

Removing

–	Remove noise insulation → General body repairs, exterior; Rep. gr.66.

–	Remove sump upper part → Chapter.

Note

The crank web of the respective cylinder must be positioned so that the socket -T10545- can be inserted in the pressure relief valve as close to vertical as possible.

Furthermore, the corners of the socket -T10545- and of the pressure relief valve must engage well.

–	Turn crankshaft via vibration damper securing bolt in direction of engine rotation until the respective bolt is accessible.

–	Unscrew pressure relief valve -1- using socket -T10545-.

–	Remove oil spray jets -2-.

Installing

Risk of damage to oil spray jets caused by deformation.Do not bend oil spray jets.

Removing and installing oil spray jets

1 -	Pressure relief valve - 27 Nm

2 -	Oil spray jet

Installation position: align leading edge of oil spray jet arrow with machined surface of cylinder block.

–	Remove upper part of sump → Chapter.

–	Install noise insulation → General body repairs, exterior; Rep. gr.66.

Removing and installing oil spray jets

Removing and installing pistons

Special tools and workshop equipment required Drift -VW 222 A- Piston ring ...

Checking pistons and cylinder bores

Checking piston – Using a micrometre, measure approx. 10 mm from the lower edge, perpendicular to the piston pin axis. ...

Other materials:

Removing and installing selector lever position display -Y26-
Removing Note The selector lever position display -Y26--1- is integrated in the selector lever gaiter and cannot be removed individually. The removal and ...

Removing and installing evaporator temperature sensor -G308-, RHD vehicles
Special tools and workshop equipment required Removal wedge -3409- Note Only vehicles with air conditioning system; on vehicles with heater, opening in heater ...

Assembly overview - speed sensor on rear axle, all-wheel drive
1 - ABS speed sensor Clean inside surface of hole before inserting sensor Coat inside surface with high-temperature paste -G 052 112 A3- Removing and installing → Chapter 2 - Bolt ...