Volkswagen Golf Service & Repair Manual: Removing and installing oil pump
– |
Remove sump (bottom section)
→ Chapter. |
|
|
|
– |
Unclip cover for oil pump drive sprocket
-arrows-. |
|
|
|
– |
Guide out oil pump with drive sprocket under drive chain. |
– |
Check that dowel sleeves -1, 3-
are fitted in oil pump. |
|
|
|
– |
Fit seal with strainer -2- in
oil pump. |
Installation is carried out in the reverse order; note the
following: |
– |
Turn oil pump drive sprocket by hand to check oil pump for
ease of movement. |
Note
– |
Fit oil pump with drive sprocket into drive chain and
secure. |
– |
Install lower part of sump
→ Chapter. |
– |
Replenish engine oil and check oil level
→ Booklet. |
→ Chapter „Assembly overview - sump and oil pump“ |
|
|
|
Special tools and workshop equipment
required
Flat scraper
Commercially available scraper
...
Special tools and workshop equipment
required
Allen key, long reach -T10058-
...
Other materials:
Assembly overview - interior monitoring, RHD vehicles
1 -
Button for deactivating interior monitoring and vehicle inclination
sensor -E616-
Removing and installing
→ Chapter
2 -
Anti-theft alarm system sensor -G578-
Removing and installing
...
Seat heating
Fig. 53 In the centre console: buttons
for the front seat heating
First read and observe the introductory information
and safety warnings The seat cushions and backrests can be heated electrically
when the ignition is switched on. Some seat versions have heated backrests.
Do not switch o ...
Synchronising the vehicle key
First read and observe the introductory information
and safety warnings It may no longer be possible to lock or unlock the vehicle
with the remote control if the button
is pressed repeatedly outside of the effective range of the vehicle key. If this
is the case, the vehicle ke ...
© 2016-2024 Copyright www.vwgolf.org