VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing oil pressure regulating valve -N428-

Removing
  Note
Fit all heat insulation sleeves in the original position when installing.
–  Remove noise insulation → General body repairs, exterior; Rep. gr.66.
–  Detach heat insulation sleeves.
   
–  Disconnect electrical connector -1-.
  Note
Place a cloth underneath to catch escaping engine oil.
–  Unscrew bolt -2- and pull off valve for oil pressure control -N428-.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Renew O-ring.
–  Install noise insulation → General body repairs, exterior; Rep. gr.66.
Specified torques
→ Chapter „Assembly overview - oil filter/oil pressure switch“
 

Removing and installing oil pressure regulating valve -N428-

Removing and installing oil pressure switch for reduced oil pressure -F378-
Special tools and workshop equipment required     Jointed wrench 24 mm -T40175- Remo ...

Checking oil pressure
Special tools and workshop equipment required     Oil pressure tester -V.A.G 1342- P ...

Other materials:

2-pack fine filler
Designation:   2-pack fine filler -LSP 784 002 A2- Issued 06/2011 Product description The 2-pack fine filler is a very fine, thixotropic polyester filler. ...

Assembly overview - flanging tool
The flanging tool for brake lines -VAS 6056- can be used to flange brake lines with an outer pipe diameter of 5 mm without damaging the coating. In certain cases, this allows sections of brake lines to be renewed at less expense.   N ...

Removing and installing lower part of sump
Special tools and workshop equipment required Flat scraper Commercially available scraper Sealant remover Hand drill with plastic brush attachment ...

© 2016-2024 Copyright www.vwgolf.org