Volkswagen Golf Service & Repair Manual: Removing and installing oil level and oil temperature sender -G266-

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Engine lubrication / Sump, oil pump / Removing and installing oil level and oil temperature sender -G266-

Removing

–	Drain off engine oil.

–	Disconnect electrical connector -3-.

–	Undo nuts -1- and remove oil level and oil temperature sender -G266--item 4-.

Installing

Installation is carried out in the reverse order; note the following:

Note

Renew seal -2-.

–	Replenish engine oil and check oil level → Booklet.

Specified torques

→ Chapter „Assembly overview - sump and oil pump“

Removing and installing oil level and oil temperature sender -G266-

Assembly overview - sump and oil pump

Note Metal shavings or a large quantity of small metal particles found during engine repair could indicate that the crankshaft bearings or conrod bearings are damaged. To ...

Removing and installing lower part of sump

Special tools and workshop equipment required Flat scraper Commercially available scraper ...

Other materials:

Function and operation
Fig. 180 In the lower section of the centre console: Driving Mode Selection button First read and observe the introductory information and safety warnings The driver can choose from up to 5 different driving modes with a variety of characteristics: Driving m ...

Things to note for diesel vehicles
Fig. 189 Tank flap open: misfuelling prevention device in the fuel filler First read and observe the introductory information and safety warnings The fuel filler in diesel vehicles can be fitted with a misfuelling prevention device . The misfuelling prevention device ensures that the ...

Tyre sealant
Tyre sealant, use-by date The tyre sealant in the bottle has a limited shelf-life. The bottle therefore has an expiry date -arrow-. Renew tyre sealant when the expi ...