Volkswagen Golf Service & Repair Manual: Removing and installing number plate light -X4-/-X5-
Note
If an LED number plate light is faulty, the entire number
plate light must be renewed. |
– |
Turn light switch to “0” position. |
|
|
|
– |
Press retaining lug in -direction of
arrow- and take number plate light downwards out of the
bumper cover. |
|
|
|
– |
Release connector -arrow- and
disconnect. |
Install in the reverse order of removal, observing the
following: |
Note
Insert number plate light into bumper cover so that
connector is oriented to left side of vehicle. |
|
|
|
Note
If an LED number plate light is faulty, the entire number
plate light must be renewed.
Removing:
– ...
Other materials:
Removing and installing storage compartment
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removing
–
Unbolt front seat and tilt it towards rear. Do not remove
...
Emptying fuel tank if it is less than 3/4
full
Special tools and workshop equipment required
Removal wedge -3409-
Wrench -T10202-
Torque wrench -V.A.G 1332-
Fuel extractor -VAS 5190-
Fuel extractor -VAS 5190 A- for E 85 fuel (not shown).
&nb ...
Checking the coolant level and refilling coolant
Fig. 195 In the engine compartment: mark
on the coolant expansion tank
Fig. 196 In the engine compartment: coolant
expansion tank cap
First read and observe the introductory information
and safety warnings The warning lamp for the engine coolant will light up
if the engine coolant leve ...
© 2016-2024 Copyright www.vwgolf.org