VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing net partition mounting

     
Removing
–  Remove net partition → Chapter.
–  Remove bolts -2-.
–  Remove insert -3- and mounting -1- from right rear seat backrest (2/3).
 

Removing and installing net partition mounting

Installing
Install in reverse order, but note the following:
  Note
  Note installation position of insert -1- and mounting -2-.
  Secure mounting -2- in left threaded holes.
  Fit locating lug on insert -1- into recess in mounting -2-.
  Clean remnants of locking fluid from thread with a wire brush. Then, fit bolts using locking fluid ( → Electronic Parts Catalogue ).
  Also clean locking fluid from threaded holes (e.g. using thread chaser).
Specified torques
  → Chapter „Assembly overview- net partition“
 
Removing and installing net partition
Removing –  Fold down both rear seat backrests. –  Pull net partition -1- towards right out of mount ...

Removing and installing bracket for net partition
Removing –  Remove luggage compartment side trim → Chapter. –  Pull belt webbing aside, a ...

Other materials:

Saw-tooth wear
Saw-tooth wear is a stepped wear pattern on the individual tread blocks → Fig. that can cause increased tyre noise. The saw tooth is caused by uneven deformation of the tread blocks in the tyre's contact patch. Saw-tooth wear is more pronounce ...

Checklist
To ensure your own safety and the safety of your passengers, observe the following actions in the specified order : Stop the vehicle at a safe distance away from moving traffic and on a suitable surface . Switch on the hazard warning lights using the button . Switch on the ...

Removing and installing wiper motor -V-
Special tools and workshop equipment required     Torque wrench -V.A.G 1410-   Torque wrench -V.A.G 1331-   Note ...

© 2016-2024 Copyright www.vwgolf.org