Volkswagen Golf Service & Repair Manual: Removing and installing mounting plate with retaining strap
| Special tools and workshop equipment
required |
|
|
|
| |
|
Removal wedge -3409 |
| |
|
Torque wrench -V.A.G 1783- |
| – |
Open front centre armrest. |
| – |
Unclip trim strip -1- in
-direction of arrow A- using
removal wedge -3409-, and remove it. |
| – |
Carefully remove mounting plate with retaining strap
-3- in
-direction of arrow B-, until connectors are accessible. |
| – |
Disconnect connectors on mounting plate with retaining strap
-3-, and remove mounting plate with
retaining strap. |
 Note
| Before installing, check all fasteners for damage and renew
if necessary. |
| Installation is carried out in reverse order. |
|
|
|
| Component |
Specified torque |
| Mounting plate with retaining
strap on centre console |
1.5 Nm |
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
...
Special tools and workshop equipment
required
Removing
Front bracket
...
Other materials:
Removing and installing backrest heating element -Z7-/-Z9-
Removing
If the backrest padding in a vehicle with seat heating is
renewed, then the respective backrest heating element must also
be renewed.
–
Separate backrest cov ...
Checklist
The following actions must always be carried out in the given order
in preparation for changing the wheel :
In the event of a flat tyre, park your
vehicle on a firm and level surface at a safe distance from the flow of traffic.
Switch on the electronic parking brake
Braking, st ...
Bringing air conditioning system into service after charging
Note
If the air conditioner compressor was removed, the V-belt
pulley /freewheel must be turned by hand approx. 10 times prior
to initial operation. This prevents any damage occurring from a
fluid hammer in the air conditioner compressor when th ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing centre console insert
Removing and installing centre console retainer, for all vehicles except
e-Golf