Volkswagen Golf Service & Repair Manual: Removing and installing mounting bracket, RHD vehicles
– |
Remove wiper arms
→ Electrical system; Rep. gr.92. |
– |
Remove plenum chamber cover
→ General body repairs, exterior; Rep. gr.50. |
– |
Remove wiper motor -V-
→ Electrical system; Rep. gr.92. |
|
|
|
– |
Remove dash panel end cover on driver side
→ General body repairs, interior; Rep. gr.70. |
– |
Remove footwell cover on driver side
→ General body repairs, interior; Rep. gr.68 |
– |
Remove storage compartment on driver side
→ General body repairs, interior; Rep. gr.68 |
– |
Remove dash panel cover on driver side
→ General body repairs, interior; Rep. gr.68. |
– |
Remove knee airbag
→ General body repairs, interior; Rep. gr.69. |
|
|
|
– |
Remove footwell vent -1- on
driver side
→ Heating, air conditioning system; Rep. gr.87. |
– |
To do this, unscrew bolt -2-
and remove footwell vent on driver side
-1-. |
– |
Unbolt crash bar for brake pedal and lay it to one side
→ General body repairs, interior; Rep. gr.70. |
– |
Separate brake pedal from brake servo
→ Chapter. |
|
|
|
– |
Release connectors -arrows- and
pull off. |
– |
Remove accelerator pedal module -1-
from mounting bracket -2-
→ Rep. gr.20. |
|
|
|
– |
Unclip wiring harness -2- from
mounting bracket -1--arrows-. |
|
|
|
– |
Remove nuts -arrows- from
mounting bracket -1-. |
|
|
|
– |
Secure brake servo -1- against
falling. |
Install in reverse order of removal, observing the
following: |
|
|
|
– |
Ensure to route wiring harness -2-
correctly so that it is not trapped. |
– |
Clip wiring harness -2- to
mounting bracket -1--arrows-. |
– |
Connect brake pedal to brake servo
→ Chapter. |
→ Chapter „Assembly overview - brake pedal, RHD vehicles“ |
Crash bar
→ General body repairs, interior; Rep. gr.70. |
Footwell vents
→ Heating, air conditioning system; Rep. gr.87. |
Knee airbag
→ General body repairs, interior; Rep. gr.69. |
Covers on driver side
→ General body repairs, interior; Rep. gr.68 |
Windscreen wiper system
→ Electrical system; Rep. gr.92 |
Plenum chamber cover
→ General body repair, exterior; Rep. gr.50 |
|
|
|
Remove dash panel end cover on driver side
→ General body repairs, interior; Rep. gr.70.
–
Remove footwell cover on driv ...
Special tools and workshop equipment
required
Release tool -T10159B-
–
...
Other materials:
Fuse table
Fig. 230 In the dash panel: fuse layout
First read and observe the introductory information
and safety warningsThe table shows the fuse locations for the items of electrical
equipment which are most relevant to the customer. The left column contains the
location, the other columns contain t ...
Charging, replacing, disconnecting and connecting the vehicle battery
First read and observe the introductory information
and safety warnings Charging the battery
The vehicle battery should be charged by a qualified workshop, as the technology
used in factory-fitted batteries requires voltage-limited charging . Volkswagen
recommends using a Volkswagen deal ...
Preparing new windows for installing
Note
The area on which the adhesive bead is applied is not
precoated or primed.
The sealing lip is included with a new windscreen.
No win ...
© 2016-2024 Copyright www.vwgolf.org