Volkswagen Golf Service & Repair Manual: Removing and installing manually operated anti-dazzle interior mirror,
without rain and light sensor -G397- and front camera for driver assist systems
-R242-
| – |
Turn interior mirror -2- anti-clockwise
-arrow- by 90° (1/4
turn). |
| – |
Remove interior mirror -2- from
glued-on retaining plate -1-. |
 Note
| Before installing, check all fasteners for damage and renew
if necessary. |
| Installation is carried out in reverse order. |
|
|
|
1 -
Front cover
For mirror base
2 -
Retaining plate
For interior mirror
Bonded to windscreen
3 -
Rear cov ...
Removing
–
Swing interior mirror downwards by approx. 25° as far as
stop.
–
Pull rear cover -2- d ...
Other materials:
Cleaning battery clamp and battery terminal
Special tools and workshop equipment
required
VAG 1331
Note
The use of penetrating fluid, contact spray or grease etc.
is prohibited since the missing adhesion ...
Cleaning the engine compartment
First read and observe the introductory information
and safety warnings The engine compartment of any motor vehicle is a hazardous
area .
The engine compartment should be cleaned by a qualified workshop. Corrosion protection
could be removed and electrical components damaged if the com ...
Removing and installing B-pillar trim on rear door
Note
Removal and installation are described only for the left side.
Removal and installation of the right side are similar.
Removing
–
Run door window down to bottom position.
–
Pull window channel -3- in area ...
© 2016-2024 Copyright www.vwgolf.org
Assembly overview - automatic anti-dazzle interior mirror, with rain and
light sensor -G397- and front camera for driver assist systems -R242-
Removing and installing manually operated or automatic anti-dazzle interior
mirror, with rain and light sensor -G397- and without front camera for driver
assist systems -R242-