Volkswagen Golf Service & Repair Manual: Removing and installing lumbar support adjustment switch -E176-/-E177-
 Note
| Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate. |
|
|
|
| – |
Remove seat trim on sill side
→ Chapter. |
| Installation is carried out in reverse order. |
|
|
|
| Component |
Specified
torque |
| Bolt -1- |
1 Nm |
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removing
...
Special tools and workshop equipment
required
Special pop rivet pliers -V.A.G 1753B-
...
Other materials:
Function of air quality sensor -G238-
The air quality sensor detects noxious substances in the
ambient air (primarily petrol and/or diesel fumes).
The Climatronic control unit -J255- evaluates the signal
from the air quality sensor -G238-. The air conditioning system
i ...
Diesel particulate filter
First read and observe the introductory information
and safety warnings The diesel particulate filter filters out soot particles
in the exhaust gas. The soot particles are collected in the filter and burnt off.
To assist in this combustion process, Volkswagen recommends that you avoid making ...
Wheel cover
Fig. 220 Removing the wheel covers
First read and observe the introductory information
and safety warningsRemoving the wheel covers
Take the box spanner and wire hook from the vehicle toolkit.
Insert the wire hook into one of the holes in the wheel cover.
Push the box spanner thr ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing storage compartment
Removing and installing lumbar support adjustment motor
-V125-/-V126-/-V129-/-V130-