Volkswagen Golf Service & Repair Manual: Removing and installing luggage compartment light -W3-
Caution
Danger of damage to component surfaces. |
When using leverage tools, mask visible areas of the
component with commercially available adhesive tape. |
|
|
|
|
– |
Press in locking lug -1- using
a flat screwdriver and lever out luggage compartment light -W3--2-. |
– |
Disconnect electrical connector -3-. |
|
|
|
– |
If necessary, lever off heat shield
-2- on both sides at arrows -A-. |
– |
Remove heat shield -2- from
glove compartment light -W3--1-. |
|
|
|
– |
Press contact plate -1- of
light in direction of arrow. |
– |
Remove festoon bulb -2- from
bulb holder. |
Install in the reverse order of removal, observing the
following: |
– |
If present, attach heat shield to luggage compartment light. |
– |
Insert luggage compartment light into opening and engage it
on opposite side. |
|
|
|
Removing
Note
The selector lever position display -Y26--1-
is integrated in the selector lever gaiter and cannot be removed
...
Note
If an LED vanity mirror light is faulty, the entire light
must be renewed.
Removal and installation are described for ...
Other materials:
Rear brakes
The type of brake system installed in the vehicle is
indicated among other things by the corresponding PR number on
the vehicle data sticker.
The vehicle data sticker can be found in the spare wheel
well and in the service schedule.
...
Removing and installing pistons
Special tools and workshop equipment
required
Drift -VW 222 A-
Piston ring clamp, commercially available
Removing
–
...
Upper section of the centre console
Fig. 7 Overview of the upper section of
the centre console
Key for :
Indicator lamp for the front passenger
front airbag switch-off function
Vent –
–
Infotainment system (factory-fitted)
Operating display
Radio ⇒ BookletRadio,
N ...
© 2016-2024 Copyright www.vwgolf.org