Volkswagen Golf Service & Repair Manual: Removing and installing lower steering column trim
Special tools and workshop equipment
required |
|
|
|
|
|
Torque wrench -V.A.G 1783- |
– |
Remove upper steering column trim
→ Chapter. |
– |
If necessary, remove ignition key. |
– |
Unscrew bolts -1- from lower steering
column trim. To do this, turn steering wheel accordingly. |
– |
Remove lower steering column trim -2-
from steering column. |
– |
On vehicles with keyless locking and starting system disconnect
connector for immobiliser reader coil -D2-. |
Note
Before installing, check all fasteners for damage and renew
if necessary. |
Installation is carried out in reverse order. |
|
→ Chapter „Assembly overview - steering column trim“ |
|
Special tools and workshop equipment
required
Removal wedge -3409-
...
Removing
–
Remove bolts -1-.
–
Release front passenger side footwell cover
-2- from dash panel and ...
Other materials:
Assembly overview - speed sensor on rear axle, all-wheel drive
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
Removing and installing
→ Chapter
2 -
Bolt
...
General information
The drive is provided by the test rig.
For vehicles with a manual gearbox, ensure that the gear
lever is in neutral for the test. For vehicles with an automatic
gearbox, ensure that the selector lever is in
»N«.
...
Removing and installing backrest heating element -Z7-/-Z9-
Removing
If the backrest padding in a vehicle with seat heating is
renewed, then the respective backrest heating element must also
be renewed.
–
Separate backrest cov ...
© 2016-2024 Copyright www.vwgolf.org