Volkswagen Golf Service & Repair Manual: Removing and installing lower rear lid trim
Special tools and workshop equipment
required |
|
|
|
– |
Remove upper rear lid trim
→ Chapter. |
– |
Remove warning triangle. |
|
|
Removal tool -T40280 |
– |
Unclip service flaps at sides of trim -3-. |
– |
Grasp in service holes in trim. |
– |
Release trim -3- with a
»firm jerk« from mountings in rear lid
-1-. |
– |
Check if all retaining clips -4- are
inserted in trim -3-. |
– |
Unclip any retaining clips left in rear lid using removal tool
-T40280-. |
– |
Fit those retaining clips back in trim -3-. |
Note
Before installing, check all fasteners for damage and
renew if necessary. |
Installation is carried out in reverse order. |
|
→ Chapter „Assembly overview - lower rear lid trim“ |
|
|
|
Special tools and workshop equipment
required
Wedges -T10383
Removing
...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ An economic driving style
→ Driving in a fuel-efficient manner
Fuel consumption, environmental impact and wear on the engine, brakes and tyres
depend largely on three factors:
Personal driving style.
...
Removing and installing brake caliper
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Brake pedal depressor -V.A.G 1869/2-
& ...
Assembly overview - suspension strut, shock absorber, spring, multi-link
suspension
1 -
Bolt
Renew after removing
50 Nm +45°
2 -
Shock absorber
Removing and installing
→ Chapter
Note correct installation position of cable tie fastener. ...
© 2016-2024 Copyright www.vwgolf.org