Volkswagen Golf Service & Repair Manual: Removing and installing locking mechanism for rear seat backrest
| Special tools and workshop equipment
required |
|
|
|
| |
|
Torque wrench -V.A.G 1331 |
| – |
Remove trim for locking mechanism
→ Chapter. |
| – |
Release backrest cover only in area of locking mechanism
→ Chapter. |
| – |
Remove Bowden cable on backrest end from release mechanism
-1-
→ Anchor. |
| Continued for all vehicles |
| – |
Remove locking mechanism -1-
from backrest frame. |
| Installation is carried out in reverse order. |
| |
→ Chapter „Assembly overview - locking mechanism“ |
|
|
|
Special tools and workshop equipment
required
Removal wedge -3409-
...
Special tools and workshop equipment
required
Removal wedge -3409
...
Other materials:
Trailer stabilisation
First read and observe the introductory information
and safety warnings Trailer stabilisation is a subsidiary function of the
electronic stabilisation programme (ESC). The trailer stabilisation function can
detect if an attached trailer is starting to lurch from side to side.
If a lurching ...
Changing headlights over from driving on left to driving on right, LED
headlights
If a right-hand drive vehicle is driven in a left-hand drive
country, or vice versa, the headlights must be converted. This
is necessary in order to avoid dazzling oncoming traffic with
the asymmetric low beam headlights.
Note
...
Moving push button to installation position in the handle
Special tools and workshop equipment
required
Release tool -T10534-
If the push-button was pressed by mistake, the installation
position can be restored.
...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing trim for locking mechanism
Removing and installing cover frame for through-loading aperture