Volkswagen Golf Service & Repair Manual: Removing and installing lock cylinder
Removing and installing lock cylinder |
Special tools and workshop equipment
required |
|
|
|
Note
|
The removal and installation sequence is only for the
left lock cylinder. The right side is similar. |
|
Different covers -4, 6 or 7-
might be installed. |
|
|
Torque wrench -V.A.G 1783- |
– |
Remove cover cap for lock cylinder
→ Chapter |
– |
Lift covers -4 and 6- or
-7-. |
– |
Screw out bolt -8- to stop. |
– |
Press in bolt -8- with locking
mechanism -9--arrow a-. Only then is the
lock cylinder released. |
– |
Pull door handle -2- off door. |
– |
Pull lock cylinder housing -1-
perpendicular -arrow b- to the door out of
the mounting bracket -3-. |
– |
Pull door handle -2- off door. |
– |
Push lock cylinder housing -1- into
door handle bracket -3- at a right-angle
-arrow a-. |
– |
Screw bolts -5 and 8- into mounting
bracket. Bolt -8- is used to pull locking
mechanism -9- in its correct position
-arrow b-. |
Note
During installation, lock cylinder housing must be pressed against
outer door panel. |
Further installation is performed in the reverse order of removal. |
l |
It is essential that a functional check is then performed with the
door open. |
- Bolts
→ Chapter „Assembly overview - door handle and door lock“
Note
The cover cap is installed when no lock cylinder is fitted.
Removing
Special tools and workshop equipment
...
Removing
Note
Removal and installation are described only for the right
door handle. The left side is similar.
...
Other materials:
Removing and installing speed sensors on front axle -G45-/-G47
Note
Removal and installation is described for the front left
speed sensor. Removal and installation of the front right speed
sensor is analogous.
Removing
–
Raise vehicle.
&n ...
First aid
In the event of contact with the eyes or mucous membranes,
wash immediately with copious running water and summon an eye
specialist.
In the event of contact with the skin, remove wetted
clothing and wash the affected skin with copi ...
Removing and installing brake master cylinder, LHD vehicles
Special tools and workshop equipment
required
Brake filling and bleeding equipment -VAS 5234-
Torque wrench -V.A.G 1331-
...
© 2016-2024 Copyright www.vwgolf.org