Volkswagen Golf Service & Repair Manual: Removing and installing lock cylinder
Special tools and workshop equipment
required |
|
|
|
– |
Remove lower steering column trim
→ General body repairs, interior; Rep. gr.68. |
Note
For the removal of the lock cylinder it might be necessary
to fold aside the ignition key. |
For reasons of clarity, the ignition lock is illustrated in
the correct position without the ignition key. |
|
|
|
– |
Turn ignition key to “Ignition ON” position. This will align
the recess in trim -arrow- with
hole in ignition lock. |
|
|
|
– |
Press lock cylinder -1-
together with immobiliser reader coil into steering lock housing
-3-. |
– |
Remove locking pin -T40011- from hole
-2-. |
– |
Press in lock cylinder tightly until locking mechanism can
be heard to engage. |
|
|
|
1 -
Starter button -E378-
Overview of fitting locations
→ Chapter
2 -
Steering column electronics control unit -J5 ...
Removing
–
Remove lower steering column trim
→ General body repairs, interior; Rep. gr.68.
& ...
Other materials:
Warning and indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
The electronic parking brake is switched on.
Do not drive
on!
Switch off electronic parking brake .
...
Removing and installing intermediate padding, backrest with through-loading
aperture
Removing
–
Fold down lid for through-loading aperture.
–
Release locking lugs -1- using
a screwdriver and at the same time push down intermediate
padding -2- as far as stop
-arrow A-.
...
Dimensions – lettering on wing
Note
The dimensions shown here for “GTI” as an example are valid for all
emblems.
1 -
Emblem
Variations in appearance possible depending on the (special) model.
2 -
Height dimension
5.0 ± 1 mm, fr ...
© 2016-2024 Copyright www.vwgolf.org