Volkswagen Golf Service & Repair Manual: Removing and installing light switch trim
Special tools and workshop equipment
required |
|
|
|
|
|
Torque wrench -V.A.G 1783- |
– |
Remove rotary light switch -EX1-
→ Electrical system; Rep. gr.96. |
– |
Carefully remove light switch trim -1-
towards rear from dash panel. |
Note
Before installing, check all fasteners for damage and
renew if necessary. |
Installation is carried out in reverse order. |
|
→ Chapter „Assembly overview - dash panel“ |
|
|
|
Special tools and workshop equipment
required
Removal wedge -3409-
...
Special tools and workshop equipment
required
Removal wedge -3409
...
Other materials:
Assembly overview - steering column switch module, with electronic ignition
lock
1 -
Starter button -E378-
Overview of fitting locations
→ Chapter
2 -
Steering column electronics control unit -J527-
With airbag coil connector and return ring with slip ring -F138-
...
Removing and installing reversing light bulb
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
Removing
–
Turn light switch to “0” position.
...
Leaks at shock absorbers
Shock absorbers are often replaced because of externally
visible leakage. Inspections on the test rig and in the vehicle
have shown that in the majority of cases this replacement is not
justified.
Slight loss of fluid (“sweating”) at ...
© 2016-2024 Copyright www.vwgolf.org