VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing LED modules for daytime running light and side light -L176-/-L177- (“GTE” only)

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Removing and installing LED modules for daytime running light and side light -L176-/-L177- (“GTE” only)

Special tools and workshop equipment required
   
Torque wrench -V.A.G 1783-
 

Removing and installing LED modules for daytime running light and side light -L176-/-L177- (“GTE” only)

Torque screwdriver -VAS 6494-
  Note
Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.
Removing
–  Remove noise insulation → General body repairs, exterior; Rep. gr.66.
–  Remove front part of wheel housing liner → General body repairs, exterior; Rep. gr.66.
 

Removing and installing LED modules for daytime running light and side light -L176-/-L177- (“GTE” only)

–  Release connector -2- and disconnect.
–  Remove bolts -3-.
–  Remove left LED module for daytime running light and side light -L176--1- towards rear.
Installing
Install in the reverse order of removal, observing the following:
–  Insert left LED module for daytime running light and side light -L176--1- with the two pointed projections facing towards front into bumper aperture.
Specified torques
→ Chapter „Assembly overview - daytime running lights“
 

Removing and installing LED modules for daytime running light and side light -L176-/-L177- (“GTE” only)

-
Removing and installing LED modules for daytime running light and side light -L176-/-L177- (does not apply for “GTE”)
  Note Left LED module for daytime running light and side light -L176- and right LED module for daytime running light and side light -L177- are onl ...

Removing and installing dip beam screen motor -V294-/-V295
  Note Left dip beam screen motor -V294- and right dip beam screen motor -V295- are only fitted on gas discharge headlights without cornering light ...

Other materials:

Outer shoulder wear
Unsuitable use of self-levelling adjustments on pneumatic suspension system The use of the offroad level is recommended only for driving offroad. Permanent use of the offroad level during normal road operation can lead to increased tyre ...

Assembly overview - track rod, multi-link suspension, front-wheel drive
1 -  Subframe 2 -  Bolt Renew after removing 70 Nm +180° 3 -  Wheel bearing housing 4 -  Track rod Removing and installing →  ...

Safety precautions when working on fuel supply system
Risk of injury due to highly-pressurised fuel. The fuel system is under high pressure. Risk of injury due to fuel which may spurt out. –  Release high pressure before opening the fuel system.       & ...

© 2016-2024 Copyright www.vwgolf.org