Volkswagen Golf Service & Repair Manual: Removing and installing lambda probe 1 before catalytic converter -GX10-/lambda probe 1 after catalytic converter -GX7-

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Mixture preparation system, electronic inj., Gas / Lambda probe / Removing and installing lambda probe 1 before catalytic converter -GX10-/lambda probe 1 after catalytic converter -GX7-

Lambda probe 1 before catalytic converter -GX10- consists of

Lambda probe -G39-

Lambda probe heater -Z19-

Lambda probe 1 after catalytic converter -GX7- consists of

Lambda probe after catalytic converter -G130-

Lambda probe heater 1 after catalytic converter -Z29-

Special tools and workshop equipment required

Lambda probe open ring spanner set -3337-

Removing and installing lambda probe 1 before catalytic converter -GX10-/lambda probe 1 after catalytic converter -GX7-

Removing

–	Unplug corresponding electrical connector:

1 -	For Lambda probe 1 before catalytic converter -GX10-.

2 -	For Lambda probe 1 after catalytic converter -GX7-.

Removing and installing lambda probe 1 before catalytic converter -GX10-/lambda probe 1 after catalytic converter -GX7-

–	Unscrew corresponding Lambda probe using a tool from Lambda probe open ring spanner set -3337-.

1 -	Lambda probe 1 after catalytic converter -GX7-

2 -	Lambda probe 1 before catalytic converter -GX10-

Installing

Installation is carried out in the reverse order; note the following:

Note

New lambda probes are coated with an assembly paste. This paste must not get into the slots on the Lambda probe body.

In the case of a used Lambda probe grease only the thread with high-temperature paste. This paste must not get into the slots on the Lambda probe body. High-temperature paste → Electronic Parts Catalogue.

During installation, the electrical connecting cable of the Lambda probe must be attached in the same places. The wire must be prevented from touching the exhaust pipe.

Specified torques

→ Chapter „Assembly overview - Lambda probe“

Removing and installing lambda probe 1 before catalytic converter -GX10-/lambda probe 1 after catalytic converter -GX7-

Assembly overview - Lambda probe

Note New lambda probes are coated with an assembly paste. This paste must not get into the slots on the Lambda probe body. ...

Engine control unit

...

Other materials:

Fuses in the vehicle
Fig. 228 Fuse box cover in the dash panel: A: left-hand drive vehicle, to the left-hand side of the steering wheel B: right-hand drive vehicle, on the driver side Fig. 229 In the engine compartment: cover ① of fuse box with plastic pliers ② First read and observe the introductory infor ...

Adjusting Bowden cable for backrest release mechanism
WARNING Ensure backrest is locked in position (default position), otherwise it can tilt forwards in an uncontrolled manner. – Remove backrest cover and backre ...

Air recirculation mode
First read and observe the introductory information and safety warnings General notes There are different types of air recirculation mode: Manual air recirculation mode (heating system, air conditioning (manual), Climatronic). ...