Volkswagen Golf Service & Repair Manual: Removing and installing knock sensor 1 -G61

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Ignition system, glow plug system / Removing and installing ignition coils with output stage / Removing and installing knock sensor 1 -G61

Removing

–	Remove air conditioner compressor from bracket and tie up → Heating, air conditioning; Rep. gr.87.

–	Disconnect electrical connector -1-.

–	Unscrew bolt -2- and remove knock sensor 1 -G61-.

Installing

Installation is carried out in the reverse order; note the following:

–	Install air conditioner compressor → Heating, air conditioning; Rep. gr.87.

Specified torques

→ Chapter „Assembly overview - ignition system“

Removing and installing knock sensor 1 -G61

Removing and installing ignition coils with output stage

Special tools and workshop equipment required Puller -T10530- Note ...

Removing and installing Hall sender -G40-

Removing – Release hose clips -1- and -2-, and remove air pipe. ...

Other materials:

Removing and installing mounting bracket for backrest release mechanism
Special tools and workshop equipment required Special pop rivet pliers -V.A.G 1753B- Hand drill Safety goggles ...

Assembly overview - transverse link, multi-link suspension, four-wheel drive
1 - Washer 2 - Nut Renew after removing 3 - Upper transverse link Removing and installing → Chapter 4 - Washer 5 - B ...

Checking fuel delivery rate
Special tools and workshop equipment required Removal wedge -3409- Remote control for V.A.G. 1348 -V.A.G 1348/3A- Multimeter e.g. hand-held multimeter -V.A.G 1526E- Test instrument adapter/DSO (5-pin) -VAS 5565- ...