Volkswagen Golf Service & Repair Manual: Removing and installing interface for entry and start authorisation system
-J965-
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester. |
The removal and installation procedures are described for
LHD vehicles. Removal and installation for RHD vehicles are
similar. |
– |
Remove footwell cover on driver side
→ General body repairs, interior; Rep. gr.68. |
– |
Remove knee airbag with igniter
→ General body repairs, interior; Rep. gr.69. |
|
|
|
– |
Press bracket -2- of interface
for entry and start authorisation system -J965--1-
at top in direction of arrow -A-. |
– |
Remove interface for entry and start authorisation system
-J965--1- from bracket
-2- in direction of arrow
-B-. |
– |
Disconnect electrical connector -3-. |
|
|
|
– |
Press locking detent -1- to
disconnect connector. |
– |
Swing retainer in -direction of arrow-
and pull off connector. |
|
|
|
– |
Lever out catch -1- in
-direction of arrow A-, using a
narrow screwdriver if necessary. |
– |
Remove bracket -2- from support
-3- in direction of arrow
-B-. |
Install in the reverse order of removal, observing the
following: |
– |
Ensure that bracket for interface for entry and start system
-J965- engages audibly. |
– |
Ensure that interface for entry and start system -J965-
engages audibly in bracket. |
|
|
|
Removing and installing door exterior handle contact sensor -G415-/-G416-
Note
The driver door exterior handle contact sensor -G415- or
front passenger door exterior handle contact sensor -G416- is
integrated in the respective exterior door handle and cannot be
renewed individually if defective. |
– |
Removing and installing door handle
→ General body repairs, exterior; Rep. gr.57. |
|
|
|
1 -
Luggage compartment aerial for entry and start system -R137-
Removing and installing
→ Chapter
2 -
Interface f ...
Special tools and workshop equipment
required
Release lever -80 - 200-
Removing
...
Other materials:
Primary locking element
The primary locking mechanism is what fixes an individual
crimp contact in the contact housing.
If necessary, any housing catches in place (secondary
locking mechanisms) must be released or removed prior to
disengaging the contacts using ...
Removing and installing rear left vehicle level sender -G76-, torsion beam
axle
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removing
–
Disconnect co ...
Performing maintenance test
WARNING
It is not permissible to test or charge batteries
whose colour indicator is light yellow. Do not
slave/jump start the vehicle!
Danger of explosion when checking and charging ...
© 2016-2024 Copyright www.vwgolf.org