Volkswagen Golf Service & Repair Manual: Removing and installing insulation
– |
Lever retaining clips -2- out of bonnet
-3- using removal lever -80-200-. |
– |
Pull insulation -1- out of elongated
holes -arrows-. |
l |
When installing insulation -1-, ensure
that retaining clips -2- are fitted with
wide side outwards. |
– |
Slide insulation -1- with fitting lugs
-arrows- in longitudinal holes. |
– |
Insert all retaining clips -2- into
bonnet -3-. |
Special tools and workshop equipment
required
Note
Removal and installation are described for ...
Removing
–
Open and support bonnet.
WARNING
Proceed with care if gas strut is reused. Spring clip must
not be le ...
Other materials:
Removing and installing upper rear lid trim
Special tools and workshop equipment
required
Wedges -T10383
Removing
–
Detach retaining straps for rear shelf on left and right from window
...
Checking fuel pressure, engine code CWVA
Special tools and workshop equipment required
Removal wedge -3409-
Pressure tester -VAS 6550-
Connector cable -VAS 6550/3-3-
Connector cable -VAS 6550/3-4-
Vehicle diagnostic tester
...
Assembly overview - water drainage hoses
1 -
Rear water drain hose
Left and right
Cleaning
→ Chapter
Removing and installing
→ Chapter
2 -
Front water drain hose
Left and right
Cleaning
→ Chapter
Removing and installing
...
© 2016-2024 Copyright www.vwgolf.org