Volkswagen Golf Service & Repair Manual: Removing and installing headlight range control unit -J431-/control unit for
cornering light and headlight range control -J745-, RHD vehicles
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester. |
– |
Remove dash panel end trim on driver side
→ General body repairs, interior; Rep. gr.68. |
|
|
|
– |
Release spreader clip -2- and
pull it out. |
– |
Remove headlight range control unit
-1- towards rear. |
– |
Disconnect electrical connector -3-. |
|
|
|
– |
To do so, press locking detent -1-,
swing retainer in -direction of arrow-
and pull off connector. |
Install in the reverse order of removal, observing the
following: |
|
|
|
– |
Press spreader clip -2- into
opening -3- in control unit
-1-. |
– |
Engage spreader clip by turning it 90°
-arrow-. |
|
|
|
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Warning lamp
→ Checking the electrolyte level of the vehicle battery
→ Charging, replacing, disconnecting and connecting the vehicle battery
The vehicle battery is a component of the electrical ...
Removing automatic distance control unit from and installing on retaining
plate, variant 1
Removing:
→ Anchor
Installing:
→ Anchor
Adjusting adjustment screws:
→ Anchor
Renewing clips on adaptive cruise control unit -J428-:
→ Anchor
...
Assembly overview - rear lid
1 -
Rear lid
Removing and installing
→ Chapter
Adjusting
→ Chapter
2 -
Bonnet lock
Removing and installing
→ Chapter
3 -
Bolts
Qty. 2
20 Nm
...
© 2016-2024 Copyright www.vwgolf.org