Volkswagen Golf Service & Repair Manual: Removing and installing headlight range control unit -J431-/control unit for
cornering light and headlight range control -J745-, LHD vehicles
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester. |
– |
Remove dash panel end trim on driver side
→ General body repairs, interior; Rep. gr.68. |
– |
Remove driver side knee airbag
→ General body repairs, interior; Rep. gr.69. |
|
|
|
– |
Release spreader clip -3- and
pull it out. |
– |
Remove headlight range control unit
-1- towards rear. |
– |
Disconnect electrical connector -2-. |
|
|
|
– |
To do so, press locking detent -1-,
swing retainer in -direction of arrow-
and pull off connector. |
Install in the reverse order of removal, observing the
following: |
|
|
|
– |
Press spreader clip -2- into
opening -3- in control unit
-1-. |
– |
Engage spreader clip by turning it 90°
-arrow-. |
|
|
|
1 -
Control unit
Removing and installing
→ Chapter
Versions without cornering light:
Headlight range control un ...
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
...
Other materials:
Vehicles with breakdown set, saloon
Depending on equipment level, vehicles are equipped with a
breakdown set.
The breakdown set is located in the tool bag
-3- on the right in the luggage
compartment.
The breakdo ...
Removing and installing thermostat for large cooling circuit
Special tools and workshop equipment
required
Hose clip pliers -VAS 6362-
Special wrench -T10508-
R ...
Notes on safety
Safety precautions during a road test
using test and measuring equipment
Observe the following if test and measuring equipment is
required during a road test:
Risk of accidents due to distraction and inadequate securing ...
© 2016-2024 Copyright www.vwgolf.org