Volkswagen Golf Service & Repair Manual: Removing and installing headlight range control regulator -E102-
Note
The removal and installation procedures are described for
LHD vehicles. Removal and installation for RHD vehicles are
similar. |
– |
Remove rotary light switch -EX1-
→ Chapter. |
|
|
|
– |
Remove trim -2- together with
headlight range control regulator -E102- from dash panel. |
– |
Disconnect electrical connectors. |
|
|
|
– |
Press fasteners on headlight range control regulator -E102--1-
in direction of arrow -A-. |
– |
Push headlight range control regulator -E102--1-
out of trim. |
Installation is carried out in the reverse sequence. |
|
|
|
Removing and installing button for
Charisma -E735- |
Removing and installing
→ Chapter |
|
|
|
Removing and installing TCS and ESP button
-E256- |
Removing and installing
→ Chapter |
|
|
|
Removing and installing TCS and ESP button
-E256- |
Removing and installing
→ Chapter |
|
|
|
Removing and installing park assist
steering button -E581- |
Removing and installing
→ Chapter |
|
Removing and installing park assist
steering button -E581- |
Removing and installing
→ Chapter |
|
Removing and installing button for
Charisma -E735- |
Removing and installing
→ Chapter |
|
|
|
Note
The removal and installation procedures are described for
LHD vehicles. Removal and installation for RHD vehicles are
similar.
...
Special tools and workshop equipment
required
Removal wedge -3409-
...
Other materials:
Removing and installing control motor sender for VARILIS headlight
-G695-/-G696-
Note
Control motor sender for left VARILIS headlight -G695- and
control motor sender for right VARILIS headlight -G696- are only
fitted on gas discharge headlights.
The control motor sender for VARILIS headlight is l ...
Removing and installing fuel rail
Removing
The fuel system is under high pressure.Risk of injury due to fuel which
may spurt out.Release high pressure.
→ Chapter
Risk of functional impairment due to soiling
→ Chapter.
...
Removing and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted
to the body flange and then rolled on.
Note
When the seal is removed, the sealant on the inside of the seal will
be spread and the flanks will be bent out slightly. If the seal is then
refitted, sealing and fir ...
© 2016-2024 Copyright www.vwgolf.org