Volkswagen Golf Service & Repair Manual: Removing and installing headlight range control motor -V48-/-V49- (dual
halogen headlights)
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way. |
If headlight range control motor cannot be removed as
described, headlight must be removed
→ Chapter. |
|
|
|
– |
Pull housing cover -1- off
headlight in direction of arrow -A-. |
|
|
|
– |
Release left headlight range control motor -V48--1-. |
For left headlight, turn opposite direction of arrow
-A- and |
For right headlight,turn in direction of arrow
-A-. |
– |
Turn left headlight range control motor -V48--1-
in direction of arrow -C-. |
– |
Turn height adjuster -2- in
direction of arrow -B- (lower
reflector). Maintain tension on left headlight range control
motor -V48--1- during this step. |
– |
Pull left headlight range control motor -V48--1-
out of headlamp height adjuster in direction of arrow
-C-. |
– |
Disconnect electrical connector. |
Install in the reverse order of removal, observing the
following: |
Caution
Risk of damage to the headlight. |
Make sure the housing cover is correctly seated when
installing. The ingress of water will lead to permanent
damage to the headlight. |
|
– |
Connect electrical connector whilst pushing in left
headlight range control motor -V48-. |
– |
Pull reflector towards rear and press left headlight range
control motor -V48- into headlight range adjuster until motor
can be heard to engage. |
– |
Engage left headlight range control motor -V48--1-
in direction of arrow -A-. |
– |
Turn height adjuster -2-
opposite direction of arrow -B-.
The reflector must move. |
– |
Check headlight setting and adjust headlight if necessary
→ Booklet36.1 |
|
|
|
If a right-hand drive vehicle is driven in a left-hand drive
country, or vice versa, the headlights must be converted. This
is necessary in order to avoid dazzling on ...
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
...
Other materials:
Assembly overview - Bowden cable
1 -
Release lever
In the interior
2 -
Frame
In lock carrier trim
3 -
Grommet
In cross panel.
4 -
Bowden cable
From gearbox to release lever
Forms o ...
Removing and installing pop-up cylinder, »R«
Special tools and workshop equipment
required
Drip tray
Removing
Note
Removal and installation are described for the left side.
Removal and installation on the right side are c ...
Hot air blower, 220 V / 50 Hz -VAS 1978/14-
Caution
When shrink-fitting, take care not to damage any
other wiring, plastic parts or insulating material with
the hot air blower.
Observe the operating instructions of the hot ai ...
© 2016-2024 Copyright www.vwgolf.org