Volkswagen Golf Service & Repair Manual: Removing and installing head restraint
Note
| |
The head restraints can be renewed with front seat installed. |
| |
The release button of the driver seat is located on outer right side
in direction of travel. The release button of the front passenger seat
is located on inner left side in direction of travel. |
| – |
Move front seat to foremost and lowest position and tilt backrest by
45°. |
| – |
Press padding in area of head restraint guides downwards a little. |
| – |
Push safety catch -1- of each of the
two head restraint guides towards the holding tube as far as it will go. |
| – |
Pull head restraint out of backrest. |
| Installation is carried out in reverse order. |
|
Special tools and workshop equipment
required
Removal pliers -3392-
Note
...
Removing
–
Remove backrest cover and backrest padding
→ Chapter.
...
Other materials:
Vibration, vibration control system
Using the vibration control system -VAS 6230 A- you can
perform more functions than just stationary balancing.
A special feature of this system is the testing of the
radial force of the wheel and tyre while rolling.
A ro ...
Permanent underbody protection -D 314 D38 M2-, light
Designation:
Permanent underbody protection -D 314 D38 M2-, light
Issued 02.2010
Product description
Permanent underbody protection -D 314 D38 M2- is a light,
transparent, no ...
Assembly overview - dual clutch
1 -
Hinge mounting
For large engaging lever “K 1”
Cannot be renewed.
2 -
Ball pin
For small engaging lever “K 2”
Removing and installing
→ Anchor
...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing lumbar support adjustment
Removing and installing head restraint guide