VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing handle for seat height adjustment

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Seat frames / Front seats / Removing and installing handle for seat height adjustment

  Note
The handle for seat height adjustment can be renewed with front seat installed.
Removing
  Note
  •   Remove handle for seat height adjustment as described. Do not knock handle for seat height adjustment off lever.
  •   If the tab is damaged when the handle for seat height adjustment is removed, the handle cannot be refitted. The handle for seat height adjustment has to be renewed then.
   
–  Pull handle for seat height adjustment -1- as far as possible upwards and hold it in this position.
–  Guide a small screwdriver through handle for seat height adjustment -1- and trim -2- up to catch -3-.
–  Push locking lug -3- inwards using screwdriver.
–  Simultaneously pull handle for seat height adjustment -1- in -direction of arrow- off lever -4-.
Installing
Install in reverse order, but note the following:
–  Check retaining clip -3- for damage and ensure it is properly seated on lever -4-.
–  Slide handle for seat height adjustment -1- onto lever -4- until it engages.
–  After installing, ensure that retaining clip -4- is properly engaged.
–  Check firm seating by pulling on it.
  Removing and installing handle for seat height adjustment
Removing and installing seat depth adjustment
Special tools and workshop equipment required       Removal wedge -3409- Removi ...

Removing and installing lower seat pan frame with seat longitudinal adjustment motor -V28-/-V31-
Removing –  If possible, move front seat to highest position to reduce as much tension on torsion rod as possible. ...

Other materials:

Assembly overview - A-pillar trim
  Note The illustration shows the A-pillar trims on the left side. The right-hand side is similar (mirror image of left-hand side).     Upper A-pillar trim and trim for triangular window 1 -& ...

Warning and indicator lamps
First read and observe the introductory information and safety warnings  Lit up Possible cause Solution Engine oil level is too low. Switch off the engine. Check the engine oil level   . ...

Removing and installing shock absorber, multi-link suspension, right shock absorber
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Torque wrench -V.A.G 1410- Spring compressor -V.A.G 1752/1- Spring retainer -V.A.G 1752/3A- Adapter -V.A.G 1752/9-, not illu ...

© 2016-2024 Copyright www.vwgolf.org