Volkswagen Golf Service & Repair Manual: Removing and installing Hall sender -G40-
| – |
Release hose clips -1- and
-2-, and remove air pipe. |
|
|
|
| – |
Disconnect electrical connector -1-. |
| – |
Unscrew bolt -2- and remove
Hall sender -G40-. |
| – |
Install in reverse order. |
| → Chapter „Assembly overview - ignition system“ |
|
|
|
Removing
–
Remove air conditioner compressor from bracket and tie up
→ Heating, air conditioning; Rep. gr.87.
...
Removing
–
Release hose clips -1- and
-2-, and remove air pipe.
...
Other materials:
Repairs and technical modifications
First read and observe the introductory information
and safety warnings Repairs and modifications must always be carried
out according to Volkswagen specifications .
Unauthorised modifications to the electronic components or software in the vehicle
may cause faults. As the electronic co ...
Removing and installing light conductor for front sill panel moulding
ambient lighting -W67-/-W68
Note
The light conductors for front sill panel moulding ambient
lighting -W67-/-W68- are integrated into the sill panel
mouldings and cannot be renewed individually.
If the light conductor for front sill panel mouldi ...
Removing and installing clutch engagement
Removing
Dual clutch removed
→ Chapter.
–
Remove large engaging lever with small engagement bearing.
Note
The upper section of bushing cannot be removed or i ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing knock sensor 1 -G61
Removing and installing Hall sender 3 -G300-