Volkswagen Golf Service & Repair Manual: Removing and installing Hall sender 3 -G300-
– |
Release hose clips -1- and
-2-, and remove air pipe. |
|
|
|
– |
Disconnect electrical connector -1-. |
– |
Unscrew bolt -2- and remove
Hall sender 3 -G300-. |
– |
Install in reverse order. |
→ Chapter „Assembly overview - ignition system“ |
|
|
|
Removing
–
Release hose clips -1- and
-2-, and remove air pipe.
...
Special tools and workshop equipment
required
Socket AF 4 mm -T10370-
Removing
...
Other materials:
Checking metering pump -V54- with end sealing valve
–
If you are uncertain as to whether the metering pump -V54--C-
has an end sealing valve or not, connect e.g. hand vacuum pump
-VAS 6213- to connection -A-.
–
Use hand-operated vacuum pump to a generate a vacuum of ...
Dimensions – lettering on wing
Note
The dimensions shown here for “GTI” as an example are valid for all
emblems.
1 -
Emblem
Variations in appearance possible depending on the (special) model.
2 -
Height dimension
5.0 ± 1 mm, fr ...
Removing and installing speed sensor on rear axle -G44-/-G46-
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
Rear left speed sensor -G46--1-.
...
© 2016-2024 Copyright www.vwgolf.org