Volkswagen Golf Service & Repair Manual: Removing and installing glow plug with flame monitoring -Q8
| – |
Dismantling and assembling auxiliary heater
→ Chapter. |
|
|
|
| – |
Pull out retaining spring -1-
in direction of -arrow-. |
| – |
Remove retaining plate -2-. |
| – |
Pull out glow plug with flame monitoring -Q8--3-. |
| Install in reverse order. |
 Note
|
|
|
| Observe location of retaining spring
-1- and retaining plate -2-. |
| → Chapter „Assembly overview - auxiliary heater attachments“ |
|
|
|
Removing
–
Switch off electrical consumers.
–
Switch off auxiliary and supplementary heater and switch o ...
Removing
–
Dismantling and assembling auxiliary heater
→ Chapter.
...
Other materials:
Removing and installing charge air cooling pump -V188-
Special tools and workshop equipment
required
Hose clamps up to 25 mm -3094-
Drip tray for workshop hoist -VAS 6208-
...
Removing and installing centre console trim in footwell
Note
Removal and installation is described for the centre console
trim in footwell on driver side. Follow same instructions for
the front passenger side as appropriate.
Special tools and workshop equipment
required
...
Introduction
This chapter contains information on the following subjects:
→ Indicator lamps
→ Turn signal and main beam lever
→ Switching lights on and off
→ Lights and vision – functions
→ Main beam assist
→ Switching over headlights ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing covers for auxiliary heater control unit -J364
Removing and installing temperature sensor -G18- and overheating sensor
-G189