Volkswagen Golf Service & Repair Manual: Removing and installing glove compartment light -W6-
| – |
Turn light switch to “0” position. |
|
|
|
| – |
Press in locking lug -1- using
a flat screwdriver, and lever out glove compartment light
-2-. |
| – |
Disconnect electrical connector -3-. |
| Install in the reverse order of removal, observing the
following: |
 Note
| If an LED glove compartment light -W6- is faulty, the entire
light must be renewed. |
| – |
Insert glove compartment light into opening and engage it on
opposite side. |
|
|
|
1 -
Driver side illuminated vanity mirror -W20-
In the case of vanity mirrors with LED lighting, the entire light
must be renewed in the event of a faul ...
Note
If an LED glove compartment light -W6- is faulty, the entire
light must be renewed.
Removing
–
...
Other materials:
Leaks or internal damage (e.g. noises or lack of power)
–
Drain refrigerant circuit.
–
Remove air conditioner compressor.
Note
In the event of internal damage (to air conditioner
compressor), purge with R134a refrigerant
→ ...
Blender
Designation:
Blender -LVE 013 100 A2-
Issued 10.2012
Product description
Blender was developed to guarantee easy blending-in of
2-pack clear coats and top coats.
...
Dismantling and assembling drive shaft, constant velocity joint VL100
Special tools and workshop equipment required
Thrust plate -VW 401-
Thrust plate -VW 402-
Press tool -VW 408 A-
Press tool -VW 411-
Tube -VW 416 B-
Thrust washer -VW 447 H-
&nbs ...
© 2016-2024 Copyright www.vwgolf.org
Overview of fitting locations – lights in roof trim
Renewing bulb for glove compartment light -W6-