Volkswagen Golf Service & Repair Manual: Removing and installing gearbox mounting
– |
Release hose clips -1- and
-2-, and remove air pipe. |
– |
Remove air filter housing
→ Chapter. |
– |
Remove battery tray
→ Electrical system; Rep. gr.27. |
– |
Release fastener -arrow-,
detach engine control unit -J623- and place to one side. |
|
|
|
Remove engine control unit
→ Chapter. |
|
|
|
– |
Unscrew nuts -arrows- and
remove bracket -1-. |
Note
Different types of brackets are fitted depending on version. |
|
|
|
– |
Unclip cable guide -1- upwards
-arrows- and push slightly to one
side. |
– |
Supporting engine in installation position
→ Chapter „Supporting engine in installation position“ |
|
|
|
– |
Remove bolts -arrows- and
detach gearbox mounting -1-. |
Installation is carried out in the reverse order; note the
following: |
Note
Renew bolts tightened through an additional specified angle. |
Gearbox support and support arm of gearbox mounting must be
perfectly parallel to each other before screwing in bolts
-arrows 1-. If necessary, lift
gearbox at rear using trolley jack. |
Only remove support bracket -10 - 222 A- when bolts on
assembly mounting have been tightened to specified torque. |
– |
Lift gearbox with spindle of support bracket until gearbox
support makes contact with support arm of gearbox mounting. |
– |
Checking adjustment of assembly mountings
→ Chapter. |
– |
Detach support bracket -10 - 222 A- from engine. |
→ Chapter „Assembly overview - assembly mountings“ |
→ Chapter „Assembly overview - air filter housing“ |
→ Electrical system; Rep. gr.27 |
→ Chapter „Removing and installing engine control unit -J623-“ |
|
|
|
Removing
–
Disconnect electrical connector -1-.
–
Move clear hos ...
Remove noise insulation
→ General body repairs, exterior; Rep. gr.66.
– ...
Other materials:
Overview of fitting locations – control units, front of LHD vehicles
1 -
Data bus diagnostic interface -J533-
Assembly overview
→ Chapter
2 -
Bracket
Assembly overview
→ Chapter
3 -
Onboard supply control unit -J519-
...
Introduction
This chapter contains information on the following subjects:
→ Display and indicator lamps
→ Operating the cruise control system (CCS)
The cruise control system (CCS) helps to maintain an individual set speed when
the vehicle is travelling forwards at speeds of more than ...
Removing and installing circulation pump -V55-
Special tools and workshop equipment
required
Hose clamps, up to 25 mm -3094-
Pliers for spring-type clips -VAS 5024A-
...
© 2016-2024 Copyright www.vwgolf.org