Volkswagen Golf Service & Repair Manual: Removing and installing gas strut
– |
Open and support bonnet. |
WARNING
Proceed with care if gas strut is reused. Spring clip must
not be levered completely out of ball socket, as it will
otherwise be damaged. Gas strut will spring out of mounting,
causing damage or injury to operator. |
|
– |
Position a small screwdriver -3-
beneath spring clip -4-. |
– |
Raise spring clip -4- such that it can
be moved over ball socket -arrow a-. |
– |
Pull gas strut -1- off ball-head pins
-2--arrow b-. |
After removing gas strut -1-, slide
spring clip -4- back immediately. |
– |
When the gas strut is disposed, gas needs to be released from gas
strut
→ Chapter. |
– |
Press gas strut -1- on ball-head pins
-2-. |
|
Component |
Specified torques |
Ball-head pin |
20 Nm |
|
Removing
–
Lever retaining clips -2- out of bonnet
-3- using removal lever -80-200-.
–
...
Clamp gas strut in vice in area x = 50 mm.
WARNING
Wear protective goggles when sawing.
...
Other materials:
Checklist
The following actions must always be carried out in the given order
in preparation for changing the wheel :
In the event of a flat tyre, park your
vehicle on a firm and level surface at a safe distance from the flow of traffic.
Switch on the electronic parking brake
Braking, st ...
Wheel alignment procedure
Always adhere to the following procedure!
Note
The vehicle must always be in unladen condition when
measuring wheel alignment
→ Chapter.
–
T ...
Knee airbags
Fig. 75 On the driver side: location of
the knee airbag
Fig. 76 Deployment zone of the knee airbag
First read and observe the introductory information
and safety warnings The knee airbag on the driver side is located in the
lower part of the dash panel . The airbag location is identi ...
© 2016-2024 Copyright www.vwgolf.org