VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing fuse holder, battery

Removing
–  With ignition switched off, disconnect earth cable from battery → Chapter.
   
–  Open cover -1-.
–  Remove nut -3-.
–  Lay positive wire -2- to one side.
–  Remove nut -5-.
–  Remove fuse holder -4- from battery terminal clamp.
Installing
Installation is carried out in the reverse sequence.
Specified torques
→ Chapter „Overview of fitting locations – fuse box, battery (vehicles with high-voltage system)“
 

Removing and installing fuse holder, battery

Removing and installing relay and fuse carrier behind dash panel, RHD vehicles
Removing –  With ignition switched off, disconnect earth cable from battery → Chapter. –  ...

Control units
...

Other materials:

Distribution of the refrigerant circuit components and their influence on the high-pressure and low-pressure sides
On the high-pressure side, there are the condenser, the receiver and the restrictor or expansion valve that acts as the separation between the high-pressure fluid and low-pressure fluid sides. High pressure is created because the restric ...

Incorporation of heat exchanger for high-voltage battery into coolant circuit of high-voltage system
  Note Fill coolant and bleed coolant circuit → Rep. gr.19. The illustration below shows only some of the components of the coolant circuit for the high-voltage system. For components which are not sho ...

Assembly overview - rear side airbag
1 -  Seat bolster 2 -  Electrical wiring From rear side airbag igniter on driver side -N201-/rear side airbag igniter on front passenger side -N202-   WARNING Observe safety instructions for pyrote ...

© 2016-2024 Copyright www.vwgolf.org